Service - Lennox Core Unit Controller Setup Manual

Table of Contents

Advertisement

9.3.

Service

9.3.1. Component Test
For cooling, the following tests can be run:
Cooling Stages 1 through 4 - Tests are discharge and return air temperatures, compressor status and percent demand.
Same tests listed above is available for all compressors present.
For heating, the following tests can be run:
Heat Stages 1 through 4 - Tests are discharge and return air temperatures, and percent demand.
Other tests:
Blower Speed
Damper Position
Power Exhaust
Outdoor Fans 1 through 4
COMPONENT TEST
COOLING STAGE 1
COOLING
COOLING STAGE 2
COOLING STAGE 3
COOLING STAGE 4
BLOWER
BLOWER SPEED AND CFM
DAMMPER POSITION
DAMPER
POWER EXHAUST
FAN 1
OUTDOOR
FAN
FAN 2
FAN 3
FAN 4
OUTPUTS
SERVICE RELAY = ON OR OFF
Figure 24. Component Test Menu Structure
COOLING STAGE 1, 2, 3 OR 4
COMPRESSOR 1, 2, 3 OR 4
COMPRESSOR 2, 2, 3 OR 4
COMPRESSOR 3, 2, 3 OR 4
COMPRESSOR 4, 2, 3 OR 4
START & STOP TEST
DAMPER POSITION AND DAMPER FEEDBACK
STATUS
START & STOP TEST
FAN 1, 2, 3 AND 4 STATUS
22
START & STOP TEST
START & STOP TEST
START & STOP TEST

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Core Unit Controller and is the answer not in the manual?

Table of Contents

Save PDF