Core Service App Menu Selection Overview; Pairing Core Service App To Core Unit Controller; System Overview - Room Sensor Mode - Lennox Core Unit Controller Setup Manual

Table of Contents

Advertisement

4. CORE Service App Menu Selection
Overview
Refer to "9. CORE Service App RTU Menu" on page 8
for details for Setup, Data, Service and Settings options.
MENU
_____
RTU MENU
_____
_____
5. Pairing CORE Service App to CORE Unit
Controller
The mobile application is compatible with the CORE
Unit Controller.
The mobile application can discover the CORE Unit
Controller if within 50 feet of the mobile device being
used.
The mobile application will list the units by signal
strength.
The unit friendly name is displayed.
Select the desire unit from the discovery list. The four
digit code desired on the unit will show the code listed in
the discovery list.
Once the unit has been selected, connection should be
established to your device within 10 seconds.
Information displayed once pairing is completed will be
RTU name, model number, serial number and firmware
version.
SETUP
INSTALL
NETWORK
INTEGRATION
TEST AND BALANCE
DATA
ALARM HISTORY
DATA TRENDING
FACTORY
RUNTIMES
SYSTEM DATA /
SENSORS / OUTPUTS
SERVICE
COMPONENT TEST
REPORT
ADVANCED
CONTROL
FIRMWARE UPDATE
SETTINGS
RTU OPTION
INSTALL

6. System Overview - Room Sensor Mode

a. The system overview shall put emphasis on the zone
temperature and RH.
The zone temperature / rh indicates a "_ _" if out
of range.
The RH value will not appear if not configured.
b. The system overview in room sensor mode places
emphasis on the current operating modes.
c. The system overview indicates all active operating modes
with a priority on heating and cooling associated modes.
NOTE:
If dehumidification mode is active, this is displayed,
and not cooling for example,
d. The system overview lists the following parameters at the
top of the screen:
Return Temperature
Discharge Temperature
Setpoints (Heating and Cooling)
Network Status
The system overview shall also indicate:
Occupancy
RH setpoint (if applicable)
Outdoor Air Temperature
Damper Position (if equipped)
Active Alerts
e. Additional Settings
PreInstall
Test
Smoke
Off on Alarm
Delay up to 5 minutes
Delay up to 20 seconds
Start up
Low Ambient Lockout
Morning Warm-Up
Pre-Cool
Free Cooling
Cooling
Heating
Dehumidification
Fresh Air Cooling
Fresh Air Heating
Cool + Max Open Economizer
Cool + Modulate Economizer
Compressor Load Shedding
Blower On - OAS
Blower On
No Demand - OAS
7

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Core Unit Controller and is the answer not in the manual?

Table of Contents

Save PDF