Agilent Technologies U1701B User's And Service Manual page 33

These initial sets can be modified, please refer to the
limits"
used to restore the default factory settings.
The following procedures will guide you on how to set compare mode:
U1701B User's and Service Guide
for detailed description. Besides that, the power- on option can be
1 Press key momentarily to enter HI/LO Audible Alert mode.
The meter locks range in this mode. The
indicated, and the secondary display will indicate C01 to C25 or the
previously saved set during last operation. The first left digit means
comparison mode. The last two digits indicate current comparison
set. The primary display will indicate the present measurement. The
meter is ready to test.
2 Press
key momentarily to select different sets. The
secondary display will indicate C01 to C25 according to which
comparison set has been selected. Press and hold SAVE key for more
than 1 s to save comparison set for next entry.
3 Press HI/LO key to cycle through the HI/LO value used for
comparison and back to ready mode. The HI/LO limits will be briefly
indicated on the primary display, and then back to the ready mode.
4 If the reading is out of the HI/LO limits, the beeper will beep three
times and the secondary display will indicate nGo. If the reading is
within the HI/LO limits, the beeper will beep once and the secondary
display will indicate Go. After 3 s, the meter will return to ready
state.
5 Press and hold the
alert mode.
Features and Functions 2
annunciator will be
key for more than 1 s to exit audible
"Setting HI/LO
21