Table of Contents
Advertisement
M1 – M3 Display units
6.2.
GENERALITIES
The following information can be seen of the upper part of the screen.
Name of the active
part reference an
formula. Here Part 1
with Channel 1
Advanced functions:
It is possible to enter a characteristic name, either with an RS232 command, or by
scanning a QR code.
After this, the characteristic name is written instead of P1 : C(1).
Characteristic name,
entered with RS232 or
QR code
Static or
dynamic (Max,
Min etc...)
Inside or outside
measurement
Unit : mm,
µm, or inch
Page 27
Advertisement
Table of Contents
Need help?
Do you have a question about the M1 and is the answer not in the manual?