Chapter 7: Assemble Door Frame With Transom; Section 7.1: Secure Transom Verticals To Header - Nabco GT1175 Installation Manual

GT1175 Standard and Pocketed Slide Doors Installation Manual; with Opus Controller
P/N C-00370
Fixed Sidelite: Removable Cover side of Header must face the Exterior side of building.
2. Orientate the Frame in relation to the building:
Full Open: Removable Cover side of Header must face the Interior side of building.
X
X
3. Secure the Header to each Jamb Tube with (6) 1/4-20 x .75 Whizlock screws.
a. If installed correctly there will be a 1/8 inch gap between the bottom of Jamb Tubes and the flat surface.
1/4-20 x .75"
Whizlock Screw
DN 1349
CHAPTER 7: ASSEMBLE DOOR FRAME WITH TRANSOM
SECTION 7 .1: Secure Transom Verticals to Header
1. Place the Header on a flat surface. Align the Transom clips to the pre-drilled holes on top.
2. Secure Transom Clips to Header with 10 x 1-3/4 inch Phillips Pan Head screws.
a. Please refer to the orientation sticker located on the Header for proper location and orientation.
Orienta on S cker
Top of Header
3. Obtain Transom Verticals.
4. Secure (1) Transom Vertical to each Transom Clip with 1/4-20 x 1" Flat Head screws.
8 of 62
Header
Transom Horizontal
Glass or Panel
Slide Door
Jamb Tube
DN 0688
HEADER COVER SIDE
Jamb Tube
Transom Ver cal
Header
Fixed or Breakout Panel
Ver cal Transom Clip
www.NabcoEntrances.com
1/8" gap
Figure 4 Secure Jamb Tubes to Header
Figure 5 Parts of the Transom
10x1-3/4"
Pan Head Screw
Header Cover
Figure 6 Attach Transom Clips
Rev 11-12-20
DN 0419