Section 11.1: Install The Bottom Pivot; Section 11.2: Install The Full Open Sidelite Onto The Upper Pivot And Bottom Pivot - Nabco GT1175 Installation Manual

GT1175 Standard and Pocketed Slide Doors Installation Manual; with Opus Controller
P/N C-00370
Attention: The Full Open Interior Sidelite does not use the Limit Arm or Ball Detents .
SECTION 11 .1: Install the Bottom Pivot
Bo om Pivot
DN 1045
1. Go to the bottom of the Pivot Jamb Tube. Insert the Bottom Pivot into the hole.
2. Secure the Bottom Pivot to the Pivot Jamb Tube with (1) 1/4-20 x 1/2 inch Phillips Head screw.
3. Go to the screw hole located in front of the Barrel. Secure the Floor Pivot to the Threshold with (1) 1/4-20 x 1/2 inch Screw.
4. Insert (1) 1/4 x 2-3/4 inch Phillips Head Screw inside the Barrel. Tighten. Cap the Barrel with (1) Bushing.
SECTION 11 .2: Install the Full Open Sidelite onto the Upper Pivot and Bottom Pivot
1. Position the Swing Sidelite Panel over the Bottom Pivot at 90° angle.
2. Locate the Bottom Pivot inside the Pivot Stile (at the bottom). Slide Bottom Pivot on top of Barrel.
3. Go to the Top Pivot that is pre-installed inside the Pivot Stile. Push the Top Pivot down by pressing on the Spring Pin.
4. Align the Top Pivot with the Pivot Hole located at the bottom of Header.
5. Release the Spring Pin to allow the Top Pivot to snap up into the hole. Ensure the Top Pivot fully engages the hole.
a. If necessary, use a flathead screwdriver to lift up on the Spring pin until the Pivot Pin is fully seated within the hole.
b. Ensure not to pinch Cable Wiring.
Hole
Spring Pin
DN 2160
18 of 62
1/4-20 x 1/2"
Phillips Head Screw
DN 1046
1/4-20 x 1/2"
Phillips Head Screw
Figure 34 Temporarily Secure Bottom Bracket to Jamb Tube
Jamb Tube
Bo om Pivot
Barrel
Figure 35 Slide Bottom Pivot on top of Barrel
Pivot S le
Break Out
Direc on
www.NabcoEntrances.com
1/4 x 2-3/4"
Tapcon Screw
Cable Wiring from
Main Harness
(Inside Header)
Top Pivot
Spring Pin
Figure 36 Insert Top Pivot into Header
Rev 11-12-20
Bushing