Section 14.1: Secure Slide Door To Belt Clips; Section 14.2: Install Bottom Guide To Slide Door - Nabco GT1175 Installation Manual

GT1175 Standard and Pocketed Slide Doors Installation Manual; with Opus Controller
P/N C-00370
SECTION 14 .1: Secure Slide Door to Belt Clips
Do not test Breakout until all adjustments are made and doors are secured .
CAUTION
1. Cover the Sidelite Panel with cardboard on the side that will face the Slide door.
DN 1903
Do not rotate the Roller Axle counter-clockwise . Doing so will unthread the Axle from the
CAUTION
Roller Assembly .
2. Go to the Carrier on top of Slide Door. Loosen (1) 7/16-20 Whiz Lock Nut on each Roller by inserting (1) 7/32" Allen wrench
into the exposed end of a Roller Axle. Hold the 7/32 inch Allen wrench in place to keep the Roller Axle stationary. At the
same time, loosen (1) 7/16-20 Whiz Lock nut with a 15/16 inch Open End Wrench.
DN 0779
3. To make it easier for rollers to "catch onto the track", slightly tilt and lift the Slide Door into the Header, and onto the Track.
4. Secure each Belt Clip to the Carrier with (2) 1/4-20 x 3/4 inch Whiz-Lock screws.
SECTION 14 .2: Install Bottom Guide to Slide Door
14 .2 .1 Insert Bottom Guide into (Full Open Slide Door) Threshold
1. Locate the Bottom Guide that was pre-installed inside the Pivot Stile located on the Slide Door.
2. Lift up the Prongs until the Bottom Guide is directly above the Guide Channels. Drop the Prongs into the Guide Channels.
24 of 62
End of Roller Axle
Carrier
Track
Carrier
Belt Clip
1/4"-20 x 3/4"
Whiz-Lock Screw
DN 1702
www.NabcoEntrances.com
Figure 54 Loosen Nuts
Roller
Figure 55 Install Carrier onto Track
Figure 56 Secure Belt Clips to Carrier
Rev 11-12-20