Section 8.2: Complete The Tie Rod Installation (For Transom Units Only); Chapter 9: Wire The Switch Assembly (Rocker Switch Or Key Switch) - Nabco GT1175 Installation Manual

GT1175 Standard and Pocketed Slide Doors Installation Manual; with Opus Controller
P/N C-00370
36"
max max
Y
DN 0767
SLIDE DOOR
Note: It is recommended to countersink holes as required to flush the surface.
Note: It is recommended to drill tap threads for 1/4 inch anchors in a steel or aluminum structure.
Note: Do not overtighten anchors to prevent deforming Jamb Tubes.
8 .1 .1 Jamb Tubes
Use 1/4 inch diameter anchors with a minimum of 3 per Jamb Tube, maximum is 48 inches on center. Drill 1/4 inch diameter holes
in the face of Jamb and then countersink each hole.
POCKETED JAMB / VERTICAL TRANSOM
1/4" Anchor
DN 0418
Use 1/4 inch diameter anchors with a minimum of 3 per Transom tube, maximum is 48 inches on center. Anchoring is
8 .1 .2 Transom Horizontal
required within 8 inches of all vertical mullions.
X
Drill 1/4 inch diameter holes in the face of Transom Horizontal and then countersink each hole.
X
8 .1 .3 Header
To prevent Header sag, use 1/4 inch diameter anchors or 3/8 inch threaded rods, with a maximum 48 inches on center. First
anchor maximum is 36 inches from each end of the Header. Drill 1/4 inch diameter holes inside the top of Header.
SECTION 8 .2: Complete the Tie Rod Installation (For Transom Units only)
1. After the Frame has been installed, slide each Tie Rod up the Channel into each 3/8-16 Anchor located in the ceiling.
a. The 3/8-16 Anchor is used to securely fasten the Frame.
2. Go to the bottom of each Tie Rod. Tighten the 3/8-16 Hex Nut and 3/8 inch Lock Washer to secure the Backing Plate.
3. Snap the Back Plate back into each Transom Vertical.
a. It may be necessary to use a rubber mallet to slightly tap the Back Plate into place.
b. Protect the surface of the Back Plate before hitting it with a rubber mallet.
CHAPTER 9: WIRE THE SWITCH ASSEMBLY (ROCKER SWITCH OR KEY SWITCH)
1. Go inside the Header. Locate the Pin wiring that is attached to the U30 Microprocessor Control, Main Harness.
2. Draw Pin wiring through a hole located at the side of Header and Jamb Tube. Continue to route wiring down the Jamb Tube.
3. Pull the Pin Wiring out, through the cut out.
4. Obtain (1) loose 5 Circuit Pin Housing from the Parts Box. Insert each Pin into the 5 Circuit Pin Housing accordingly:
a. 1 = Red, 2 = Orange/White, 3 = Blue, 4 = Green, 5 = Orange
14 of 62
48"
Y
Y
48"
max
1/4" Anchor Hole(s)
36" 48"
max max
Y
Y
Figure 21 Anchor Placement
SLIDE DOOR w/TRANSOM
SLICK JAMB
1/4" Anchor
www.NabcoEntrances.com
Rev 11-12-20
Y
48"
max
Figure 22 Screw Anchors
1/4" Anchor Hole(s)