Section 11.3: Install The Clip; Chapter 12: Install The Exterior Full Open Sidelite (Standard & Pocketed); Section 12.1: Install The Bottom Pivot; Section 12.2: Partially Install The Limit Arm - Nabco GT1175 Installation Manual

www.NabcoEntrances.com
Rev.11-12-20
SECTION 11 .3: Install the Clip
Attention: To breakout the FO Interior Sidelite, (1) Clip must be removed from Strike Stile, and (1) Clip must be
released from Header .
1. Go to the bottom of the Strike Stile. Align the screw hole located on the upper portion of Clip to the Strike Stile.
2. Use the bottom portion of the Clip as a template to mark and drill (2) 1/4 inch diameter screw holes into the floor.
3. Secure the Clip to the Strike Stile with (1)
DN 2334
CHAPTER 12: INSTALL THE EXTERIOR FULL OPEN SIDELITE (STANDARD & POCKETED)
STANDARD FULL OPEN SLIDE DOOR
Exterior
Swing Sidelite
DN 2321
SECTION 12 .1: Install the Bottom Pivot
Bo om Pivot
DN 1045
1. Go to the bottom of the Pivot Jamb Tube. Insert the Bottom Pivot into the hole.
2. Secure the Bottom Pivot to the Pivot Jamb Tube with (1) 1/4-20 x 1/2 inch Phillips Head screw.
3. Go to the screw hole located in front of the Barrel. Secure the Floor Pivot to the Threshold with (1) 1/4-20 x 1/2 inch Screw.
4. Insert (1) 1/4 x 2-3/4 inch Phillips Head Screw inside the Barrel. Tighten. Cap the Barrel with (1) Bushing.
SECTION 12 .2: Partially Install the Limit Arm
1. Slide (1) .255 ID x .900 OD x .125 THK Nylon Washer onto (1) 1/4-20 x 1 inch Phillips Head Screw.
2. Go underneath the Limit Arm. Insert the Washer and Screw up into the screw hole.
1/4-20 x 1 inch Screw, and to the
Strike S le
EXTERIOR
1/4-20 x 1/2"
Phillips Head Screw
GT1175StandardandPocketedSlideDoorsInstallationManual;withOpusController
1/4-20 x 1"L
Screw
1/4-20 x 1/2"L
Clip
Screw
POCKETED FULL OPEN SLIDE DOOR
Interior
Swing Sidelite
Exterior
Swing Sidelite
Figure 38 Sidelite and Slide Door have Breakout Capabilities
1/4-20 x 1/2"
Phillips Head Screw
Figure 39 Temporarily Secure Bottom Bracket to Jamb Tube
Floor with (2) 1/4-20 x 1/2 inch Screws.
Figure 37 Secure Clip to Strike Stile
INTERIOR
EXTERIOR
1/4 x 2-3/4"
Tapcon Screw
P/NC-00370
Bushing
19 of 62