Section 14.4: Adjust The Interlocks; Chapter 15: Permanently Install The Threshold - Nabco GT1175 Installation Manual

GT1175 Standard and Pocketed Slide Doors Installation Manual; with Opus Controller
P/N C-00370
14 .3 .3 Tighten Rollers
1. Hold the 7/32 inch Allen wrench in place to keep the Roller Axle stationary. At the same time, tighten each (1) 7/16-20 Whiz
Lock nut with a 15/16 inch Open End Wrench.
SECTION 14 .4: Adjust the Interlocks
Attention: Pocketed Slide Door Units do not use Interlocks .
1. Manually close the Slide Door. Ensure the Interlocks are properly engaged. If not, adjust the Interlocks.
Interlock Correctly Engaged
DN 2163
Note: Adjust Interlocks so there is no contact between the Rail and the Interlock. Any contact will cause the Slide Door to bind.
2. Obtain (1) parts bag taped to the Slide Door at the NABCO factory containing (4) Shims.
3. Remove the Interlock on the Sidelite, Strike Stile. Place (1+) shims directly underneath the Interlock. Line up the screw holes.
4. Secure the Interlock assembly to the Sidelite Strike Stile with (2) #10-32 x 5/8 inch Phillips Head Screws. Loosely tighten the
mounting screws just enough to keep the Interlock assembly from falling out of place.
5. Go to the Interlock located on the Pivot Stile of the Slide Door. Loosen the mounting screws.
6. Manually close the Slide Door. The loosened Interlocks will automatically adjust to proper position.
7. Tighten (2) #10-32 x 5/8 inch Phillips Head Screws to secure each Interlock to each Stile.
CHAPTER 15: PERMANENTLY INSTALL THE THRESHOLD
SECTION 15 .1: Secure Threshold to Floor
1. Go to each end of Threshold. Mark (1) drill hole approximately 4" from each edge.
2. Mark remaining drill holes to be evenly spaced.
DN 1047
26 of 62
End of Roller Axle
Carrier
DN 1903
Interlock
#10-32 x 5/8"
Phillips Head Screw
Drill Screw Holes in Metal Strip
Interlock NOT Correctly Engaged
Figure 62 Close Door to Adjust Interlocks
S le
Shim
Figure 63 Place (1+) Shim under Interlock
Figure 64 Mark and Drill Holes on Threshold
www.NabcoEntrances.com
Figure 61 Tighten Rollers
DN 0745
Example Shown:
Standard Full Open
Slide Door
Rev 11-12-20