Section 12.3: Install The Full Open Sidelite Onto The Upper Pivot And Bottom Pivot; Section 12.4: Complete Installation Of The Limit Arm - Nabco GT1175 Installation Manual

GT1175 Standard and Pocketed Slide Doors Installation Manual; with Opus Controller
P/N C-00370
3. Go to the pre-drilled screw hole located at the bottom of Header (on the Pivot Side of Sidelite).
4. Secure the Limit Arm to the Header by tightening the Screw.
a. Loosely tighten (just enough to keep the Screw assembly from falling out of the hole).
b. Limit Arm installation is completed after the Swing Sidelite is fully installed.
Limit Arm
Limit Arm Wheel
DN 0771
SECTION 12 .3: Install the Full Open Sidelite onto the Upper Pivot and Bottom Pivot
1. Locate the Bottom Pivot inside the Pivot Stile (at the bottom). Insert the Bottom Pivot into the Floor Pivot Barrel.
2. Go to the Top Pivot that is pre-installed inside the Pivot Stile. Push the Top Pivot down by pressing on the Spring Pin.
3. Align the Top Pivot with the Pivot Hole located at the bottom of Header.
4. Release the Spring Pin to allow the Top Pivot to snap up into the hole. Ensure the Top Pivot fully engages the hole.
a. If necessary, use a flathead screwdriver to lift up on the Spring pin until the Pivot Pin is fully seated within the hole.
b. Ensure not to pinch Cable Wiring.
Hole
Spring Pin
DN 2160
SECTION 12 .4: Complete Installation of the Limit Arm
1. Swing open the Swing Sidelite 90 degrees. Align and then rest the Limit Arm inside the Top Rail.
2. Open the Swing Sidelite all the way. Tighten (1) 1/4-20 x 1 inch Phillips Head screw to secure the Limit Arm to the Header.
20 of 62
.255 x .900 x .125 THK
Nylon Washer
1/4-20 x 1"
Phillips Head Screw
DN 1046
Pivot S le
Bo om of Header
Figure 40 Partially Install the Limit Arm
Jamb Tube
Bo om Pivot
Barrel
Figure 41 Install the Bottom Pivot
Cable Wiring from
Main Harness
Top Pivot
Spring Pin
Break Out
Direc on
Figure 42 Insert Top Pivot into Header
www.NabcoEntrances.com
Rev 11-12-20
Pivot Hole
(Inside Header)