Nabco GT1175 Installation Manual page 10

GT1175 Standard and Pocketed Slide Doors Installation Manual; with Opus Controller
P/N C-00370
7 .2 .2 Transoms and Jamb Tubes
1. Go underneath the Transom Horizontal. Snap-In Base Glass Stops between the Transom Verticals.
a. Ensure the tall back of Base Glass Stops face the Exterior side of building.
2. Go to the Transom Vertical. Snap-In Base Glass Stops between the Transom Horizontal and Base Glass Stops located on top
of the Header.
a. Transom Verticals should be installed just above the Base Glass Stop installed on the Header.
1" Tall, 1/4" Glass
1" Tall, 3/8" Glass
1" Tall, 5/8" Glass
1" Tall, 1" Glass
DN 2153
7 .2 .3 (1/4 inch) Glass Panel, Flush Glazing
1. Measure between the Bottom of the Transom Horizontal and the Top of the Base Glass Stop located on the Header. Cut
strips of Vinyl to that length.
2. Measure the full width of each Base Glass Stop located on the Transom Horizontal. Cut strips of Vinyl to that length.
Base Glass Stop
End of Header
DN 2148
3. On the same side as the Glass Stop, roll or press Vinyl Strips into each Transom Pocket.
a. Using a Roller, or keeping the vinyl wet with plain or soapy water, can make vinyl installation easier.
4. The other side of Vinyl Strips are installed after the Glass Panel has been put in place. Please see "SECTION 17.1: Complete
the Transom Installation".
10 of 62
1" Tall, 7/8" Glass
1" Tall, 1/2" Glass
1" Tall, 3/4" Glass
Transom Horizontal
Transom Ver cal
Transom Horizontal
EXTERIOR
1" Snap-In
Base Glass Stop
Transom Ver cal
1" Snap-In
Base Glass Stop
Example Shown for Transom Ver cals and Jamb Tubes
-looking down- onto Header
Measure full width of each Base Glass Stop
www.NabcoEntrances.com
Snap-In
Base Glass Stop
Snap-In
Base Glass Stop
EXTERIOR
Pocketed Jamb Tube
Figure 10 Install Glass Stops in Transoms
Measure between the Top
of Glass Stop and Bo om of
Transom Horizontal to cut
Vinyl Strips
End of Header
Figure 11 Measure to Cut Flush Glaze Vinyl
Rev 11-12-20
Top of
Header