Chapter 3: Scope; Section 3.1: To The Installer; Section 3.2: Objective; Chapter 4: Getting Started - Nabco GT1175 Installation Manual

www.NabcoEntrances.com
Rev.11-12-20
CHAPTER 3: SCOPE
The purpose of this manual is to familiarize the installer and purchaser with the proper installation and operation of this
SECTION 3 .1: To the Installer
system. It is essential that this equipment be properly installed and operational before the door is used by the public. It is the
installer's responsibility to inspect the operation of the entrance system to be sure it complies with any applicable standards.
In the United States, ANSI Standard 156.10 covers the GT-1175 Slide Door System and ANSI Standard Z97.1 covers Glass
Installation. Other local standards or codes may apply. Use them in addition to the ANSI standard. The GT-1175 is listed with
the Underwriters Laboratory and is identified as such on the label.
Instruct the building owners and operator on the essentials of the operation of the door and this device. The owner should
follow these instructions to determine whether the door is operating properly and should immediately call for service if there
is any malfunction. All installation changes and adjustments must be made by qualified, NABCO trained technicians.
The GT1175 Standard Slide Door system is designed to be installed within a Rough Opening of a Building. The door function
SECTION 3 .2: Objective
is controlled by the Opus Control. This control offers many features to accommodate most installation options. This manual
offers step by step instructions.
A pedestrian Door that does not have Its glass sections installed at the Factory shall specify that
CAUTION
the glazing material employed is to comply with the requirement in UL 325 par .30 .5 .1:
CHAPTER 4: GETTING STARTED
To gain access into the "myNABCO" portal, the User must first have an assigned User Name and Password. To request a User
SECTION 4 .1: Request a User Name/Password to gain access into the "myNABCO" portal
Name and Password, the following must be done:
1. Open the NABCO Website: www.nabcoentrances.com
2. Enter the "myNABCO" portal → Request Access → Fill out the Request Access Form → Click onto Register
a. A User Name and Password will be emailed back to the requestor.
SECTION 4 .2: Associated Video QR Code Link
How to locate Service Parts Pages on the
NABCO website
Mechanical Configurations:
SECTION 4 .3: Types of Units
• Single Slide: (1) Slide Door that slides to the right or left with (1) Sidelite Panel.
X
• Bi-Part: (2) Slide Doors that slide apart from the center with (2) Sidelite Panels.
GT1175StandardandPocketedSlideDoorsInstallationManual;withOpusController
"The glazing material in both fixed and sliding panels of all sliding doors and in all
unframed swinging doors shall comply with the requirements in the Performance
Specifications and Methods of Test for Safety Glazing Material Used in Buildings,
ANSI Z97 .1 . Glazing material for other pedestrian doors shall also comply with
ANSI Z97 .1, except that single strength or heavier glass may be used for those
portions of doors involving a glazed area of less than 1ft
dimension greater than 18 in (457 mm)" .
2
Android Phone Instruction to Scan QR Code
1. Google to download QR Scanner. Install.
Note: Scanning QR Links using an Android Phone may vary.
2. Place phone in front of QR Code. Scan.
1. Click on Camera icon.
I-Phone Instruction to Scan QR Code
2. Place phone in front of QR Code. Scan.
(0 .9 m ) and having no
2
P/NC-00370
5 of 62