Section 13.1: Secure The Fixed Sidelite To The Door Frame; Section 13.2: Install The Bottom Guide Inside Fixed Sidelite - Nabco GT1175 Installation Manual

GT1175 Standard and Pocketed Slide Doors Installation Manual; with Opus Controller
P/N C-00370
SECTION 13 .1: Secure the Fixed Sidelite to the Door Frame
1. Locate (2) Cut Outs on the side of the Pivot Stile. Align and then slide the Fixed Sidelite until (2) Mounting Brackets (pre-
installed on the Pivot Jamb Tube) can be seated inside each Cut Out.
2. Slide the Fixed Sidelite towards the Interior of the Building until both Mounting Brackets butt up against the inside wall of
the Pivot Stile.
Jamb Tube Moun ng Bracket
3. Locate (1) cut out at the top of Strike Stile. Align and then slide the Fixed Sidelite until (1) mounting bracket (pre-installed
under the Bottom Lip of Header) can be seated inside the Cut Out.
Moun ng Bracket
DN 0862
4. Snap a chalk line between Jamb Tubes in front of Sidelite Panel. If the Sidelite Panel is flush to the chalk line, it is square.
5. Secure the Fixed Sidelite Panel to all (3) Mounting Brackets with 1/4-20 x 1/2 inch Flat Head Screws.
DN 0624
SECTION 13 .2: Install the Bottom Guide inside Fixed Sidelite
1. Go to the bottom of Strike Stile. Remove the Bottom Guide Cover Plate.
22 of 62
Header Moun ng Bracket
(Inside Ver cal Mullion)
1/4-20 x 1/2"
Flat Head Screw
Cut Out
Strike S le
Jamb Tube
DN 0128
Figure 46 Slide Mounting Block into Top Rail
Figure 47 Slide Mounting Bracket into Cut Out
Chalk Line
Fixed Panel
Bo om Guide
Cover Plate
1/4-20 x 3/4"
Phillips Screw
www.NabcoEntrances.com
1/4-20 x 1/2"
FlatHead Screw
Cutout Clearance
Jamb Tube
Moun ng Bracket
Jamb Tube
Figure 48 Ensure Fixed Panel is Square
Figure 49 Remove Bottom Guide Cover
Rev 11-12-20
DN 0863