Section 7.3: Secure Header And Transom To Pocketed Jamb Tubes; Section 7.4: Assemble The Door Frame - Nabco GT1175 Installation Manual

www.NabcoEntrances.com
Rev.11-12-20
Base Glass Stop
DN 2146
SECTION 7 .3: Secure Header and Transom to Pocketed Jamb Tubes
Note: 1175 Slide Door Units installed with a Transom are shipped with Pocket Jamb Tubes only.
1. Place the Header between the Pocket Jamb Tubes so the removable cover side is facing up. Ensure the Frame is still
orientated in relation to the building.
2. Secure the Header to each Jamb Tube with (6) 1/4-20 x .75 Whizlock screws. If installed correctly there will be a 1/8 inch gap
between the bottom of Jamb Tubes and the flat surface.
DN 0949
SECTION 7 .4: Assemble the Door Frame
NOTE: Header diagrams shown
with Access Cover removed.
FIXED SIDELITE UNITS:
ACCESS COVER TYPICALLY
FACES THE EXTERIOR
DN 2263
1. Position Jamb Tubes on either side of Header according to the instruction sticker located on each Jamb Tube, showing
proper location and orientation. Ensure the removable cover side of Header is facing up.
Fixed Sidelite: Removable Cover side of Header must face the Exterior side of building.
2. Orientate the Frame in relation to the building:
Full Open: Removable Cover side of Header must face the Interior side of building.
X
X
1/8" gap
Flat Surface
Door
Opening
GT1175StandardandPocketedSlideDoorsInstallationManual;withOpusController
Vinyl
Vinyl
Figure 12 Install Base Glass Stops and Vinyl on Same Side
1/4-20 x .75"
Whizlock Screw
1 1 8 9 1 0 1 3 1 4 1 2
2 4 3 1 6 5 7
Figure 14 Orientate the Door Frame in relation to the Building
Pocketed
Jamb Tube
Figure 13 Secure Header to Jamb Tubes
FULL OPEN UNITS:
Door
ACCESS COVER TYPICALLY
Opening
FACES THE INTERIOR
P/NC-00370
Vinyl
11 of 62