Section 10.2: Install The Recessed Threshold; Chapter 11: Install The Interior Full Open Sidelite (Pocketed) - Nabco GT1175 Installation Manual

www.NabcoEntrances.com
Rev.11-12-20
SECTION 10 .2: Install the Recessed Threshold
Attention: Unit must be designed for Recessed Threshold .
1. On both the Exterior and the Interior side of Door Frame, snap a chalk line on the floor from Jamb to Jamb.
Jamb Tube
2. Create a channel that is the full width of Jamb Tubes, and 1/2 inch deep.
3. Lay down the Threshold so the Bumper Channels are on same side of Slide Doors.
4. Center the Threshold inside the channel so the full length is flush with the chalk line.
5. Ensure the channel is plumb, square, and 1/2 inch deep throughout. Failure to do so may cause Slide door to malfunction.
6. Go to each end of Threshold. Mark (1) drill hole approximately 4" from each edge. Continue to mark remaining drill holes to
be evenly spaced.
DN 1047
7. With a 1/4 inch masonry drill bit, drill through the Threshold and into the floor no less than 1-1/2 inch deep.
8. Do not permanently install the Surface Threshold until the Slide Doors are completely installed.
DN 2114
CHAPTER 11: INSTALL THE INTERIOR FULL OPEN SIDELITE (POCKETED)
Swing Sidelite
Slide Door
DN 2323
Floor Surface
DN 0761
Drill Screw Holes in Metal Strip
RECESSED THRESHOLD
POCKETED FIXED SIDELITE SLIDE DOOR
Swing Sidelite
GT1175StandardandPocketedSlideDoorsInstallationManual;withOpusController
Track
Figure 31 Mark and Drill Holes on Threshold
Metal Strip
Fasteners not provide by NABCO
Figure 33 Sidelite and Slide Door have Breakout Capabilities
1/2"
Figure 29 Track Recess
Chalk Line
Figure 30 Snap Chalk Line
Example Shown:
Standard Full Open
Slide Door
Figure 32 Secure Threshold to Flat Surface
INTERIOR
EXTERIOR
P/NC-00370
DN 2117
17 of 62