AERMEC FCLI 32 Installation Manual page 27

• Installing near a wall
If the unit is to be installed near a wall,
• Maintenance of the electric box
If you need to access the electric box for
maintenance purposes, observe the fol-
lowing indications:
- open the filter grille (make a ¼ turn of the
1
the corresponding delivery outlet can be
closed using the gasket supplied.
two bolts)
- remove the screw that blocks the corner
hatch (with the Aermec logo)
- remove the 2 screws that block the elec-
tric box
• Disassembling for maintenance
purposes
- Before carrying out any operations on the
unit, it is essential to disconnect it from
the power supply.
- To access the inside of the unit, remove
the two crossbars that are screwed
to the frame. It will then be possible to
remove the fan protection grille and the
polystyrene tray (see the figure)
- DANGER!! Before re-powering
the unit, check you have correctly
reassembled all the components
(especially the protection grille).
- pull the electric box downwards
- carry out the maintenance work
- reassemble everything, following the
above instructions in the reverse order
2 3
27