2N 9152101W Installation Manual page 63

Status signalling:
Green LED Red LED
blinking off
on off
blinking blinking
on blinking
Configuration:
Connect the
refer to the Configuration Manual
Security Relay
Press and hold the
device in the programming mode (both the red and green LEDs are blinking).
Activate the intercom switch using the keypad, telephone, etc. The first code
sent from the intercom will be stored in the memory and considered valid. After
code initialisation, the
(the green LED is blinking).
Caution
In case of resetting the factory default settings on a device with a
version of firmware 2.18 or higher it is necessary to reprogram the
®
2N Security Relay
2N TELEKOMUNIKACE a.s., www.2n.cz
Status
Operational mode
Activated output
Programming mode – waiting for initialisation
Error - wrong code received
®
2N Security Relay
is on or blinking.
®
2N Security Relay
®
2N Security Relay
using the instructions above.
to the properly set intercom switch output;
. Make sure that one LED at least on the
Reset button for 5 seconds to put the
will pass into the operational mode
®
2N
63/85