2N 9152101W Installation Manual page 32

Place the intercom into the flush mounting box while introducing the cables.
8.
Leave some of the cables inside the unit as a reserve and the rest under the
intercom bottom.
Insert the supplied screws in the side mounting holes making sure that they
9.
penetrate into the flush mounting box nuts. Tighten all the screws properly. Tip:
The screw tightening sequence may affect the intercom position.
We recommend to seal the frame – wall gap with a silicone or another sealant to
10.
avoid wall dampening as a result of water leakage.
Do not complete mounting until you have finished electrical installation.
11.
Flush Mounting – Thermally Insulated Wall
What You Need:
Longer screws (depending on the thermal insulation thickness)
Hole: (112 x 220 x 70) mm
Cut out the thermal insulation layer using the template (the same as for classic brick
wall).
2N TELEKOMUNIKACE a.s., www.2n.cz 32/85