Lubrication Service Schedule - J&M GC31t-1 Operator's Manual

IMPORTANT: Your grain cart has grease fittings at all critical points. These should be serviced before the grain cart is put into
operation.
WARNING: BE CERTAIN THAT ALL POWER IS SHUT OFF BEFORE SERVICING THE GRAIN CART
SPRING LOADED UPPER AUGER BEARING: Service the
grease fitting on the upper auger bearing (located at the top
end of the upper auger assembly) after every 8 hours of use.
Lubricate the springs and retaining bolts on the bearing before
prolonged storage of the grain cart.
PTO & DRIVELINE: The grease fittings on the
PTO should be serviced after every 8 hours of use.
Service the grease fittings on each of the drive
bearings and also the universal joint after every 8
hours of use.
HITCH: There is a grease fitting located on the
pivot shaft of the swivel hitch for grain carts
equipped without an electronic weigh system
(scales).

Lubrication Service Schedule

AUGER FOLDING MECHANISM: One grease fitting is located on
the pivot pin of the folding auger. This fitting should be serviced
after every 8 hours of use. Service the grease fitting on the hanger
bushing assembly (top end of the lower auger assembly) after every
8 hours of use or as needed.
GEARBOX: Gearbox lubricant has been added to the gearbox
during final assembly. Recheck the lubricant level before initial
operation of the grain cart, then periodically according to use. An
inspection plug is located in the center of the top of the gearbox
mount plate. To check the fluid level, remove the vented inspection
plug and drain plug at the bottom of the gearbox. Drain the
lubricant. Return the drain plug and refill the gearbox with 24
ounces (0,71 liters) of gearbox lubricant. The gearbox is properly
filled when half full of lubricant. DO NOT OVERFILL. Use EP 80-90
gearbox lubricant or equivalent.
13