J&M GC31t-1 Operator's Manual page 9

Grain cart
Table of Contents

Advertisement

IMPORTANT: Install new safety signs if the
old signs are destroyed, lost, painted over
or cannot be read. When parts are replaced
that have safety signs, make sure you install
a new sign with each new part. New signs
are available from the manufacturer or your
authorized dealer.
7
9
3
12
9
16
9
9
13
10
14
11
5
7
16
9
6
Safety Decals
ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED!
Replace Immediately If Damaged or Missing
NEVER PLAY IN OR
ON GRAIN CART
FLOWING GRAIN TRAPS AND SUFFOCATES VICTIM IN SECONDS!
13
7
KEEP HANDS, FEET, HAIR AND
5
CLOTHING AWAY FROM MOVING PARTS
1
2





12
15
4
12 & 13
Description
1
Danger_Warning_Important
2
Danger, Keep Hands and Clothing Away Decal (Small) JM0076817
3
Warning, Keep Hands Away Decal
4
Warning, Keep Lug Nuts Tightened Decal 1-5/8" x 4"
5
Danger, Keep Hands and Clothing Away Decal
6
Danger, Keep Off Ladder Decal
7
Danger, Electric Lines Decal
8
Danger, Do Not Enter Grain Tank Decal
9
Danger, Rotating Driveline Decal
10
Open Decal
11
Closed Decal
12
J&M Oval Decal (Large) 9-1/2" x 15"
13
J&M Oval Decal (Medium) 5-1/2"x8-1/2"
14
GC31t-1 OAS Stripe Complete
15
GC31t-1 AS Stripe Complete
16
Check PTO Overlap Decal
YOU CAN DIE IN
Do not adjust, service, clear, or lubricate the machine until all
SECONDS IN
power is shut off.
FLOWING GRAIN!
Keep all safety shields in place.
Keep people and objects clear of equipment before applying
power or moving machine.
Before highway travel, secure a slow-moving vehicle emblem to
the rear of the machine in accordance to the state and local
laws.
Make sure all flashers and turn/brake lights are working properly
BEFORE incidental highway travel.
CHECK TIRE INFLATION
Do not inflate tires more than 6 PSI over the recommended
pressure printed on the side of the tire.
CHECK ALL WHEEL NUTS
SERIOUS INJURY OR
Dealer or manufacturer is not responsible for damaged caused by
DEATH CAN RESULT WITH
loose wheel nuts.
ELECTRIC LINES.
HIGH-PRESSURE FLUID HAZARD
USE CARE WHEN MOVING
To prevent serious injury or death:
OR OPERATING MACHINE
• R elieve pressure on system before
NEAR ELECTRIC LINES TO
r
epairing, adjusting or disconnecting.
AVOID CONTACT.
• W ear proper hand and eye protection
w
hen searching for leaks.
• K eep all components in good repair.
1
CHECK WHEEL LUGS
Manufacturer is NOT responsible for damage
3
SERIOUS INJURY OR DEATH CAN RESULT
FROM CONTACT WITH ELECTRIC LINES.
USE CARE WHEN MOVING OR OPERATING
THIS MACHINE NEAR ELECTRIC LINES
TO AVOID CONTACT.
6
7

11
10
CHECK PTO OVERLAP
CHECK MANUAL FOR PTO LENGTH.
INCORRECT PTO OVERLAP MAY CAUSE
EXTENSIVE DAMAGE TO DRIVE SYSTEM.
16
OPERATING INSTRUCTIONS
With the gate indicator in the closed position, fill the box with
grain.
With the PTO disengaged, fold discharge auger to upright
position.
After auger is in the upright position, start the PTO at a SLOW
RATE OF SPEED until the pin on the upper auger engages the
drive dog on the bottom auger(failure to follow this procedure
may cause extensive damage to both the drive dog and the pin).
Increase PTO speed to 1000 RPM and open inner gate until the
pointer is in the halfway position. When grain begins flowing
from the discharge auger, open gate to the full position.
Once the grain has ceased to flow, return the gate to the closed
position (for complete clean-out, gradually close gate, allowing
the opening to be reduced). Disengage the PTO and allow its
rotation to come to a complete stop. Auger is now ready to be
returned to the lowered position.
Do not operate or service machine until you
read and understand operator's manual.
CHECK BEFORE EVERY SEASON.
from loose lug nuts.
4
DO NOT ENTER GRAIN TANK WHEN
AUGER IS RUNNING.
8
14
15
JM0025435
Part No.
JM0037665
JM0018039
JM0010150
JM0018035
JM0018034
JM0015099
JM0018033
JM0018036
JM0025433
JM0025434
JM0015151
JM0010179
JM0046656
JM0046655
JM0025435
KEEP HANDS AND CLOTHING
AWAY FROM MOVING PARTS.
JM0076817
2
JM0037665


5
ROTATING DRIVELINE
CONTACT CAN CAUSE DEATH.
KEEP AWAY!
• Keep all guards in place when operating.
• Do NOT stand on steps or climb ladder until
all power is shut off.
• Keep hands, feet, hair and clothing away
from moving parts.
9
9

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gc24t-1

Table of Contents