Lubrication Service Schedule - J&M 1012 Operator's Manual

IMPORTANT: Your grain cart has grease fittings at all critical points. These should be serviced before the grain cart is put into
operation.
WARNING
BE CERTAIN THAT ALL POWER IS SHUT OFF BEFORE SERVICING THE GRAIN CART
PTO & DRIVELINE: The grease fittings on the PTO should be serviced after every 8 hours of use. Service the grease fittings on each
of the drive bearings and also the universal joint after every 8 hours of use.
AUGER FOLDING MECHANISM: One grease fitting is located on the pivot pin of the folding auger. This fitting should be serviced
after every 8 hours of use. Service the grease fitting on the hanger bushing assembly (top end of the lower auger assembly) after
every 8 hours of use or as needed.
SPRING LOADED UPPER AUGER BEARING: Service the grease fitting on the upper auger bearing (located at the top end of the
upper auger assembly) after every 8 hours of use. Lubricate the springs and retaining bolts on the bearing before prolonged
storage of the grain cart.
Gearbox Lubricant
Model Ounces Input Shaft Output Shaft
1012 96 1-3/4"
Pivot Pin Once Annually
Roll Tarp U-Joint Once Annually
Upper Auger Flighting Every 8hrs of use
Driveline Every 8hrs of use
GEARBOX: Gearbox lubricant has been added to the gearbox during final assembly. Recheck the lubricant level before initial operation
of the grain cart, then periodically according to use. The fluid level should rest at the inspection plug, pictured in blue below. When
filled to the proper level, the gearbox should have 96 ounces of SAE 80W-90 lubricant. Change the oil annually before use.
16

Lubrication Service Schedule

2"