Lubrication Service Schedule - J&M X2431 Operator's Manual

IMPORTANT: Your grain cart has grease fittings at all critical points. These should be serviced before the grain cart is put into
operation.
To view the lubricating grease Safety Data Sheet, go to:
WARNING: WHEN SERVICING THE GRAIN CART BE CERTAIN ALL POWER IS SHUT OFF AND THE TRACTOR KEY
REMOVED TO PREVENT OPERATION OF TRACTOR AND CART
PTO & DRIVE LINE: The grease fittings on the PTO should be serviced after every 8 hours of use. Service the grease fittings
on each of the drive bearings and the universal joint after every 8 hours of use.
AUGER FOLDING MECHANISM: One grease fitting is located on the pivot pin of the folding auger. This fitting should be
serviced after every 8 hours of use. Service the grease fitting on the hanger bushing assembly (top end of the lower auger
assembly) after every 8 hours of use or as needed.
SPRING LOADED UPPER AUGER BEARING: Service the grease fitting on the upper auger bearing (located at the top
end of the upper auger assembly) after every 8 hours of use. Lubricate the springs and retaining bolts on the bearing before
prolonged storage of the grain cart.
GEARBOX: Gearbox lubricant has been added to the gearbox during final assembly. Recheck the lubricant level before
initial operation of the grain cart, then periodically according to use. An inspection plug is located in the center of the top
of the gearbox mount plate. To check the fluid level, remove the vented inspection plug and drain plug at the bottom of the
gearbox. Drain the lubricant. Return the drain plug and refill the gearbox with 0,71 liters (24 ounces) of gear box lubricant for
51 cm (20") auger. The gearbox is properly filled when half full of lubricant. DO NOT OVERFILL. Use SAE 80W-90 gearbox
lubricant or equivalent.
To view the gearbox lubricant Safety Data Sheet, go to:
K80 SPOON HITCH: Service the grease fitting on the socket side of the spoon hitch after every 8 hours of use.
Pivot Pin Once Annually
Roll Tarp U-Joint Once Annually
Upper Auger Flighting Every 8 hrs of use
Drive line Every 8 hrs of use
Brake Bearing Every 8 hrs of use
K80 Spoon Hitch Every 8 hrs of use
26

Lubrication Service Schedule

http://jm-inc.com/sds_10565_1_lc_ep_1.pdf
http://jm-inc.com/hd_80w90_es_gear_oil.pdf