Table of Contents
Advertisement
Parameter
Description
Decay
How long it takes for the sound to go
from the initial peak to the sustain level.
Sustain
The volume level that the sound
maintains when you hold a note.
Release
The release specifies how long the note
will continue to play and fade out when
the note is released. The release begins
when the gate signal goes low.
Clk
Choose the signal that will be used to
Source
control the envelope. Set to INT to turn
off the envelope.
6.
Push PLAY on the main screen to start the GATE Input if you chose GATE1 through GATE4 as the Clk Source, or start
the external signal driving the EXT input.
7.
Push HOME to go back to the main screen. The blue bar along the bottom of the ENV cell shows the current CV
output of the cell.
Record a CV Sequence Using the CREC Cell Type
The CREC Cell Type allows you to record a mono or stereo control voltage sequence for play back via a CPLY Cell. The recording
will take input from input jack CV 1, CV 2, or both, based on your selection in the cell parameters, and will be saved as a .WAV
file on the microSD card. The wave file is named RCxxxxxx.wav, where xxxxxx is the next sequential number available. You may
put the microSD card into your computer to rename the files. Once the file is created, it can be selected for loading into
another CPLY cell.
CREC cells can only be used in cells aligned with CV Output jacks because after you record the CV sequence, the Cell Type will
change to CPLY, and a CPLY cell will play back its output through the corresponding CV Output jack.
We will further discuss playback of the recording when we discuss CPLY and Out cell types below. To use the CREC cell type to
record a WAV file:
1.
Start by plugging a CV signal source into input CV 1, CV 2, or both to record in stereo. These are the inputs on the
edge of the module near the Clock input.
2.
Press HOME until you get to the Main screen.
3.
Touch a cell that is mapped to a CV Output jack and push INFO If needed to open it.
4.
Change the Cell Type to CREC by touching the Cell Type button next to the grid icon in the
top row of the parameters screen, and then selecting
will now see the CREC Load and Record screen.
5.
In the top menu, touch the menu item between the Cell Type button and the
In 1/2
(
in the example screenshot). This will display the list of input choices. Touch one
of the options to choose whether to record just from In 1, just from In 2, or from both inputs
in stereo.
6.
Before you start recording, set up the parameters that control the recording:
5/5/2021 4:50:00 PM
Range of Values
0.0 to 100.0% The decay percentage is a
logarithmic scale between 0 and 38 seconds.
0.0 to 100.0%
0 to 100% The release percentage is a
logarithmic scale between 0 and 38 seconds.
INT, EXT1, EXT2, EXT3, EXT4, GATE1, GATE2,
GATE3, GATE4
CREC
from the list of Cell Types. You
Copyright 1010music LLC 2021
Toolbox User Manual v 2.1.2
Modulation
No
No
No
No
Load
button
CREC Load and Record
Target?
Screen
P. 27
Advertisement
Table of Contents
