Table of Contents
Advertisement
Parameter
Description
Waveform
Choose the desired wave
shape.
Depth
The amount or amplitude
of the LFO.
Rate
The frequency of the LFO
from about 0.1Hz to 12
Hz. When Beat Sync is
On, this specifies the rate
in beats and measures.
Beat Sync
Controls the operation of
the rate parameter.
When this is ON, the
wave cycle is
synchronized with the
clock.
3.
Press HOME or touch the grid icon in the top left corner to return to the Main Screen.
Note:
•
If a value of an LFO parameter is changed during playback of the sequence, the change will take effect immediately
Configure a Control Voltage Sequencer (SEQ)
The Control Voltage Sequencer (SEQ) cells allow you to create a control voltage pattern by drawing a
bar chart on the touch screen. This signal plays out through the output jack that corresponds to this
cell. The output range for this signal is 0V to +5V. The SEQ Cell Type can only be used in cells in columns
3 and 4 because it requires a control voltage output. The SEQ Cell Type does not create a MIDI signal.
To configure an SEQ cell:
1.
From the Main screen, touch one of the SEQ cells in a column aligned with the CV Output
jacks to display the CV Sequencer screen. To change a cell to an SEQ, touch the Cell Type
button to the right of the grid icon in the top row of the cell parameters screen, and then
SEQ
touch
from the list of Cell Types.
2.
Press the INFO button to display the CV Sequencer Parameters screen.
3.
Use the control knobs to adjust the values of the parameters:
5/5/2021 4:50:00 PM
Range of Values
•
Saw
•
Rev Saw
•
Triangle
•
Pos Tri
•
Square
•
Pos Square Sine
•
Pos Sine
•
Random
0 to 100%
0 to 100%
or
1/64, 1/32T, 1/32, 1/16T,
1/16, 1/8T, 1/8, 1/4T, ¼,
1/2T, ½, 1 bar, 2 bars
(T= Triplet)
On, Off
Copyright 1010music LLC 2021
Toolbox User Manual v 2.1.2
Modulation
Target?
No
LFO Parameters Screen
Yes
Yes
No
CV Sequencer Screen
P. 25
Advertisement
Table of Contents
