Table of Contents
Advertisement
Name
Description
Note
A piano roll style sequence of notes displayed
Sequencer
with the keyboard running down the left side,
and the sequence steps scrolling from left to
(NOTE)
right. The Gate output is high when a note is
playing, and low when it is not. The CV output
varies based on the pitch of the selected note.
The MIDI signals are output through the MIDI Output Jacks on the right edge of the module. The Note Sequencer parameters
allow you to configure the MIDI port and channel for playback of each Note Sequencer. All Note Sequencers could output to
the same port and channel, or each could be routed to a different port or channel. The MIDI output is polyphonic and can play
up to 128 notes per step per port. When the sequence is recorded via MIDI input, or loaded from a MIDI file, the MIDI output
will include gate, pitch and velocity information. Notes that are placed manually via the touchscreen will include only gate and
pitch information in the MIDI output. The Note and Gate Sequencers are the only Cell Types that send a signal to the MIDI
output.
To create a Note Sequence:
1.
From the Main screen, touch one of the Note Sequencers to display the Note Sequencer
screen. To change the type of a cell to NOTE, touch the Cell Type button in the top row just
to the right of the Grid icon and select
side of the screen represents notes on a keyboard, with higher pitched notes at the top of
the screen. The vertical gray bars represent steps in the sequence. Blue rectangles
represent notes in the sequence. MIDI output can support multiple notes per step, but CV
output only supports one note per step.
2.
There are three ways to add notes to the sequence:
a.
Touch the screen at the step and note position desired.
b.
Touch Rec to record inputs coming in through the MIDI Input Jack in real time.
Touch Rec again to stop recording.
c.
Touch Step to record inputs coming in through the MIDI Input Jack with each successive MIDI input note
adding a note to the next step in the sequence. Touch Step again to stop recording.
3.
You can use the Control Knobs and touch gestures to adjust notes and to zoom and scroll through the sequencer:
Action
Turn the top left control knob
Turn the top right control knob
Turn the bottom left control knob
Turn the bottom right control knob
Two finger pinch or stretch
Single finger drag or swipe
Note:
•
Each layer of a Note sequencer cell may contain up to 512 events.
•
When the Sequencer Screen reloads, it zooms horizontally to display the number of steps that have been
selected in Step Count, and scrolls vertically to display the entered notes.
•
The cursor position is restricted to the Step Count configured for this Note Sequencer.
•
When recording, the sequencer will add the incoming notes to the sequence. It will not remove previously
existing notes. Touch Clear before touching REC if you want to start with a clean piano roll.
•
The C notes on the piano roll are numbered to indicate which octave is currently displayed. If you zoom out too
far the numbers will not be displayed.
5/5/2021 4:50:00 PM
Gate 1-8
MIDI and Gate
NOTE
. The black and white display along the left
Result
Cycles the note selection through the notes on the piano roll
Change the length of the currently selected note
Moves the position of the step cursor
Moves the currently selected note up or down through the
piano scale
Zooms the piano roll in or out
Scrolls the piano roll
Copyright 1010music LLC 2021
Toolbox User Manual v 2.1.2
Span Gate 5-8
CV 1-8
and CV 1-4
MIDI,
MIDI and CV
Gate and CV
Note Sequencer Screen
P. 22
Advertisement
Table of Contents
