To Create A Note Cell That Spans Gate And Cv Output Jacks; Clear The Notes In The Piano Roll; Copy And Paste Notes Between Note Cells; Import A Midi File Into A Step Sequencer - 1010music Toolbox v 2.1.2 User Manual

Note:
•
If a value of a Note Sequencer parameter is changed during playback of the sequence, the change will take effect at the
start of the next loop through the sequence.

To create a Note cell that spans Gate and CV Output jacks:

1. Set the Cell Type of the cell in the GATE column to be
2. Set the Cell Type of the cell in the CV column to be
columns.

Clear the Notes in the Piano Roll

Sometimes you may want to erase all of the notes in the piano roll and start over. Here's how:
1. From the Piano Roll screen, touch
from the piano roll.
2. If you only want to remove some of the notes, touch the notes you want to remove and they will be erased.

Copy and Paste Notes between NOTE Cells

The Edit menu in a NOTE cell allows you to copy notes between NOTE cells.
1. Open the Piano Roll for the source NOTE cell, and touch
Copy Cut
2. Touch or
NOTE cell.
3. Open the Piano Roll for the target NOTE cell, and touch
Paste
4. Touch in the drop down menu. All of the notes from the source NOTE cell will now be added to the target
NOTE cell.

Import a MIDI File into a Step Sequencer

Another way to get notes into a Note sequencer is to import a MIDI file from the microSD card. Follow these steps:
1. Copy a standard MIDI file onto the microSD card and then reinsert the card into toolbox.
2. From the Piano Roll screen of a NOTE cell, touch
menu.
3. Use the Control Knobs to highlight the file you want, and then touch
now display the notes imported from the MIDI file. Any previous notes in the piano roll will be erased.

Configure a Low Frequency Oscillator (LFO)

Toolbox can generate low frequency oscillation (LFO) signals by using the Cell Type of LFO for cells in columns aligned with CV
Output jacks. The outputs of these cells play through the corresponding CV Output jack in the grid below the screen. The
output range for these signals is -5V to +5V. LFOs do not generate MIDI signals.
To create and configure an LFO cell:
1. From the Main screen, touch one of the cells aligned with the CV Output jacks and then press INFO to display the cell
parameters screen. If you need to change the Cell Type to LFO, touch the Cell Type button in the top row of the
parameters screen just to the right of the grid icon, then select
2. Use the Control Knobs to adjust the values of the following parameters:
5/5/2021 4:50:00 PM
NOTE
Edit
in the top menu, and then touch
in the drop down menu. If you use
Edit
Copyright 1010music LLC 2021
Toolbox User Manual v 2.1.2
(none)
. The cell display on the main screen will now span two
Clear
. This will erase all of the notes
Edit
from the top menu.
Cut
, the notes will be removed from the currently selected
Edit
from the top menu.
in the top menu, then touch
Load
in the top right corner. The piano roll will
LFO
from the list of Cell Types.
Import
in the drop down
P. 24