To Control The Slice Sequence With A Midi Or Cv Signal - 1010music Bitbox mk2 2.1 User Manual

Bitbox MK2 2.1 User Manual
3. Touch one of the three black boxes below the Slice parameter to open the
Modulation Parameters Screen.
4. For the Source parameter, choose IN1, IN2, or EXT 1 through EXT 8
5. Set 1V/Octave to ON for now to map 1 volt of CV signal across one octave of
equivalent notes, with one slice per semi-tone. When this is set to ON, the
Amount parameter is disabled.
6. Connect a CV signal to the EXT or IN jack selected for the Source parameter.
7. Press INFO until you see the Waveform screen. Trigger playback of this pad
by pressing the triangular Play button in the top right corner of the screen
while varying the voltage sent to the selected port. Each time you press play,
the Trig modulation will play the slice mapped to the current CV value. You
will see the waveform display jump around to show which slice is being
played.
On the Modulation Parameters Screen for Slice, you can set 1V/Octave to Off and use
the Amount parameter to control how the CV voltage range is mapped to slices.
Page 76 of 97
Mar 1, 2023
Copyright 1010music LLC 2023
Mar 1, 2023

To Control the Slice Sequence with a MIDI or CV Signal:

You can use this method with CV or MIDI to control which slice will be played the next
time a slicer pad is triggered.
1. Create a Slicer Cell and create 4 or more slices as described in Work with
Slicer Cells above. One example of a WAV file to use with this feature is
\SFX\Metal\METL_shake and squeal.wav.
2. Set the following values for the pad parameters:
Parameter Value Explanation
Launch Mode Trigger This will cause the WAV slice to play from
beginning to end when a trigger is received.
Other values will work, but let's use this for
the example.
Loop Mode Off We will turn off looping for this example.
Slice 1 When a MIDI Note is received on either the
MIDI Pads channel, or the MIDI channel
configured for this pad, Slice 1 will serve as
the starting point for the sequencer.
MIDI Default We want the default behavior where the MIDI
channel selected for MIDI Pads on the Tools
screen will be used to trigger this pad.
Slice Seq Random This will cause the bitbox mk2 to select a
slice at random each time the pad is
triggered.
PlayThru OFF For this example, we want to stop sample
playback when we reach the end of the slice.
3. Slice Seq will not work unless we choose a modulation signal to work with it.
Touch one of the three black boxes below the Slice Seq parameter to bring up
the Modulation Parameters screen.
4. Choose a value for Source. For demonstration purposes choose TRIG and
touch the pad or push the Play button to trigger playback.
Copyright 1010music LLC 2023
Bitbox MK2 2.1 User Manual
Page 77 of 97