Table of Contents
Advertisement
Working in Flipped UI Mode
Flip UI
When the value for
module is installed in a rack with the touchscreen on the bottom. When flipped, the firmware adjusts how the buttons, Control
Knobs and jacks are mapped to the user interface. One noteworthy change is that the HOME and INFO buttons now reverse
functions. This is done so that HOME is always on the left and INFO is always on the right. The alignment of the knobs in this
mode is slightly high compared to the parameters on the touch screen. However, the top left control knob will control the top
left parameter, and the lower right control knob will control the lower right parameter. The Gate and Control Voltage outputs
are also now mapped to the inverted display. The Input Jacks and MIDI Outputs maintain their original assignments. The figure
below shows the faceplate labels for an inverted module.
Sequencer Settings
There are several settings that apply to all of the event sequencers and CV generators for the current preset. To configure
these settings:
1.
Press HOME to return to the Main screen if needed.
2.
Touch EXT4 and then press INFO to display the Sequencer Settings screen.
3.
Use the Control Knobs to adjust the following parameters:
Parameter
Description
Trig Play
When set to On, a high CV signal in the jack
associated with EXT4 will toggle the
playback state of Toolbox. Set this to off to
use EXT4 as a modulation source without
affecting playback state.
5/5/2021 4:50:00 PM
ON
is set to
, the user interface on the touch screen will be inverted. Use this setting when the
Inverted Faceplate Labels
Copyright 1010music LLC 2021
Toolbox User Manual v 2.1.2
Range of Values
On, Off
Sequencer Settings Screen
P. 14
Advertisement
Table of Contents
