Table of Contents
Advertisement
Using Presets
Before we start creating our own sequences, let's make sure the module is setup properly by playing back some content from a
preset that comes with the module.
Select a Preset
A preset is a set of pre-configured event sequences, CV generators and modulators. You can use the
1010music presets or create your own. By default, toolbox opens the first preset in alphabetical
order when it starts up. To select a different preset:
1.
Press the HOME button to display the Main screen if needed.
2.
Touch the Pset button on the Main screen to display the Preset Selection screen.
3.
Turn a knob to select the desired preset.
4.
Touch Load to load the selected preset and go back to the Main screen.
Save a Preset
Toolbox does not automatically save your changes to presets. You have to manually save by
following these steps:
1.
From the Main screen, touch the Pset button to display the Preset Selection screen.
2.
Touch Save to save the changes to the preset and return to the Main screen, or touch File
then Save As to save the changes to a different preset.
Toolbox allows you to switch presets in real time to switch all patterns at once. If you switch presets
during playback, the change will take effect at the beginning of the next bar. This change is
quantized to the measure to give you smooth transitions.
Learn more about managing presets in Preset Management below.
Start Playback of the Event Sequencers and CV Generators
Toolbox comes with presets that demonstrate the use of the event sequencers and CV generators. Let's play one of them to
demonstrate the use of the module. Select one of the two supplied presets: STABS or BBQ. Note that these presets have Gate
sequencers configured for Gate outputs 2 and 3.
To control playback of all of the sequencers and function generators:
1.
Press the HOME button to display the Main screen if needed.
2.
Touch a cell on screen to toggle the active playback state. Cells with a white border are active and will run when you
start playback. Make sure at least one loaded cell is active. More than one may be active at a time.
Play
3.
Touch
in the lower left corner of the screen to toggle playback on and off. The
active.
4.
You can also use the bottom CV Mod In jack to control playback. Each high signal received on the bottom CV Mod In
jack will toggle playback on and off.
Note:
•
When the module is mounted with the screen on top, CV Mod In 4 controls playback. When the module is configured to
run with the Flipped UI and the screen on the bottom, CV Mod In 1 controls playback.
Toolbox will now generate a sequence of gate signals out through the Gate Output jacks 1, 2, 3 and 4, if the corresponding cell
is configured. These gate signals can trigger notes on another module. Listen to the output of the receiving module to hear the
sequences. Other outputs may be sent to other jacks if the corresponding cells are configured, and are not muted.
5/5/2021 4:50:00 PM
Copyright 1010music LLC 2021
Toolbox User Manual v 2.1.2
Preset Selection Screen
Preset File Submenu
Play
button is blue when it is
P. 16
Advertisement
Table of Contents
