Table of Contents
Advertisement
Note:
•
If you record into a loaded cell, the original WAV file remains intact on the microSD card and a new WAV file is
created.
Load a CV WAV file using a CREC Cell
You can also use a CREC cell to load a WAV file into a CPLY cell:
1.
Press HOME until you get to the Main screen.
2.
Touch a cell that is aligned with a CV Output jack to open it.
3.
Change the Cell Type to CREC by touching the Cell Type button next to the grid icon in the top row of the parameters
screen, then select CREC from the list of Cell Types. You will now see the Load and Record screen.
4.
Touch Load from the top menu to display the WAV file selection screen. Use the Control Knobs to scroll through the
list of WAV files until the highlight is over the desired file.
5.
Touch Load in the top right corner to load the selected file. The cell is then changed to a CPLY cell, and the CPLY Wave
screen is shown with the selected WAV file loaded.
Play Back a CV WAV File Using a CPLY Cell
The CPLY cell will play back a CV sequence that was recorded as a WAV file. You can put the microSD card into your computer
to add WAV files to the card, or follow the steps above to record a new CV sequence. The CPLY cell can only be used in cells
mapped to CV Output jacks because the output is played out via the corresponding CV Output jack below the screen. CPLY cells
do not output MIDI signals. CPLY cells may be paired with one or more OUT cells to play up to 8 channels from the WAV file.
To Create a CPLY cell:
1.
Complete a recording or loading of a CREC cell as described above, or set the cell type to CPLY for a cell mapped to a
CV Output jack.
2.
Press the INFO button to cycle between the CPLY Wave screen and the CPLY Parameters Screens.
3.
Configure the following parameters of the cell to control playback:
Parameter
Description
Amount
Adjusts the level of the voltage output signal.
Launch
This controls how a note trigger affects the
Mode
playback of a cell.
Play
Controls the playback speed of the CV signal.
Rate
100% plays the file back at the original
recorded speed. Values between 99 and 0
will reduce the playback speed to the
corresponding percentage. Values from -1 to
-100 will cause playback to reverse.
5/5/2021 4:50:00 PM
Range of Values
-100% to 100%
selected, the control voltage is inverted.
AlwaysOn
: The cell plays back continuously.
Trigger
: Playback starts when the selected
Clk Source signal has a high Gate value. Playback
will continue through the end of the sequence.
Gate:
Begin the cell playback in the same
Trigger
manner as
mode, playback will stop when the Gate signal
goes low.
-100 to 100%
Copyright 1010music LLC 2021
Toolbox User Manual v 2.1.2
Mod
Target?
Yes
When a negative value is
No
Gate
mode. But in
Yes
P. 29
Advertisement
Table of Contents
