Table of Contents
Advertisement
Quant
Defines precisely when to
Size
restart the sequence when
using the internal clock.
When the sequence ends,
toolbox will wait until the
start of the next Quant
Size interval to restart the
sequence.
Step
The number of steps in
Count
the sequence. You may
need to scroll to see all of
the steps. The screen will
always display at least 16
steps, but the sequencer
will only move through the
number of steps selected
here.
Clk
This parameter allows you
Source
to use an alternative input
as the clock signal. By
default, the toolbox
internal clock (INT) will be
used.
4.
Press the INFO button again to return to the CV Sequencer Screen.
5.
On the CV Sequencer screen, use touch gestures and control knobs to configure the values of the
sequencer steps. When the sequence is playing the cursor will move across the step bars to show the
current playback position. Touch a step bar to set the value at the height selected. Turn the left control
knobs to move the cursor through the bars. Turn the right control knobs to adjust the height of the bar at
the currently selected step.
6.
Touch the grid icon in the top left corner, or press HOME to return to the Main screen.
Note:
The CV Sequencer Screen always shows the same number of steps and allows the cursor to be positioned over
•
all of the steps. However, only the number of steps selected in the Step Count parameter will be used during
playback.
To set the value of a step to 0, use the control knobs to adjust the value.
•
If a value of a CV Sequencer parameter is changed during playback of the sequence, the change will take effect
•
at the start of the next loop through the sequence.
Record a CV Sequence Using the CREC Cell Type
The CREC Cell Type allows you to record a mono or stereo control voltage sequence for play back via a CPLY Cell.
The recording will take input from input jack CV 1, CV 2, or both, based on your selection in the cell parameters, and
will be saved as a .WAV file on the microSD card. The wave file is named RCxxxxxx.wav, where xxxxxx is the next
sequential number available. You may put the microSD card into your computer to rename the files. Once the file is
created, it can be selected for loading into another CPLY cell.
CREC cells can only be used in cells aligned with CV Output jacks because after you record the CV sequence, the
Cell Type will change to CPLY, and a CPLY cell will play back its output through the corresponding CV Output jack.
We will further discuss playback of the recording when we discuss CPLY and Out cell types below. To use the CREC
cell type to record a WAV file:
P. 20
6/13/18 7:54 PM
1/64, 1/32T, 1/32, 1/16T,
1/16, 1/8T, 1/8, 1/4T, ¼,
1/2T, ½, 1 bar, 2 bars
(T= Triplet)
1 to 64
INT, EXT1, EXT2, EXT3,
GATE1, GATE2, GATE3,
GATE4
Digital Heart – Analog Soul
Toolbox User Manual
No
Yes
P arameters Screen
No
Copyright 1010music LLC 2017
Figure 1 9: SEQ
Advertisement
Table of Contents
