Table of Contents
Advertisement
Toolbox User Manual
Connect a M IDI Controller Input
Toolbox allows you to record Note Sequences from a MIDI input. If your MIDI controller has a mini TRS audio jack
connector, then you can try to plug it directly into the MIDI Input Jack using a standard patch cable. However, there
are competing standards for implementing mini TRS audio jacks for MIDI, so you may need to use a MIDI adapter. If
it has a 5 Pin DIN connector, use an appropriate MIDI Adapter. Read the blog post Mini TRS Audio Jacks for
MIDI Connections Compatibility Guide on our website at
https://1010music.com/stereo-minijacks-
midi-connections-compatibility-guide
for more details about the MIDI adapter.
Toolbox accepts input from all MIDI channels.
General M odule Settings
Before we dive into using the module, we will configure two general module settings:
and
.
RecToPlay,
Flip UI
To access these settings, press and hold the HOME button until you see the Menu
screen shown in Figure 4: Menu Screen to the right. The number in the lower right corner
of the screen displays the current version of the firmware installed on the module.
From the Menu Screen, touch
to display the Settings screen. Use the Control
Settings
Knob closest to the parameter to adjust its value.
Figure 4 : Menu Screen
When
is
, toolbox will automatically play a newly recorded sample when
RecToPlay
ON
recording completes. This only works when a time duration is selected for the recording
Length parameter. When it is off, the sample will not be automatically played.
The
setting will turn the user interface upside down so you can use the module
Flip UI
with the touchscreen on the bottom. As soon as you change the value for
, the
Flip UI
user interface will be inverted. This means you will need to change which Control Knob
you use to change it back.
Press the HOME button twice to go back to the Main screen.
Figure 5 : Settings Screen
W orking in Flipped UI M ode
When the value for
is set to
, the user interface on the touch screen will be inverted. Use this setting
Flip UI
ON
when the module is installed in a rack with the touchscreen on the bottom. When flipped, the firmware adjusts how
the buttons, Control Knobs and jacks are mapped to the user interface. One noteworthy change is that the HOME
and INFO buttons now reverse functions. This is done so that HOME is always on the left and INFO is always on the
right. The alignment of the Control Knobs in this mode is slightly high compared to the parameters on the touch
screen. However, the top left control knob will control the top left parameter, and the lower right control knob will
control the lower right parameter. The Gate and Control Voltage outputs are also now mapped to the inverted
display. The Input Jacks and MIDI Outputs maintain their original assignments. The figure below shows the
faceplate labels for an inverted module.
P. 8
6/13/18 7:54 PM
Copyright 1010music LLC 2017
Digital Heart – Analog Soul
Advertisement
Table of Contents
