Table of Contents
Advertisement
4.7 Punch Module
4.7.1 Punch Module Removal
The Back Gauge assembly must be removed before removing the Punch Module.
See "Back Gauge Assembly" on page 4.6.
Tools Required
• Phillips screw driver or 1/4" nut driver
• Diagonal wire cutter
• Retaining ring pliers
• 5/64" Allen Wrench
To remove the Punch Module:
1. Remove the Back Gauge assembly.
2. Use an Allen wrench to remove the Punch Cycle knob [1].
3. Remove the 4 Punch Module retaining screws from the front panel [2].
[1]
[2]
Figure 4.49 Knob and Punch Module Front Retaining Screws.
91
Advertisement
Table of Contents
