Table of Contents
Advertisement
4.5.2 Aligner Panel Removal
Removing the Aligner panels provides access to the paper path and the Aligner belt
(green belt). The procedure is the same for the entrance and exit Aligner panels
except that the exit side has a docking plate instead of a docking bracket, which must
be removed first.
To remove the Aligner panel:
1. Remove the docking bracket [1].
[3]
[3]
[1]
[4]
[2]
Figure 4.23 Entry Side Aligner Panel.
2. Release the Aligner latch [2].
3. Remove the E-clips from both ends of the Aligner shaft [3].
3. Slide the shaft out the front of the punch [4].
68
Advertisement
Table of Contents
