Table of Contents
Advertisement
7.5 Docking Bracket Installation
The docking brackets are shipped in a
separate bag along with size M4
mounting screws (not shown). There
are 2 lengths supplied. You may need
to use the longer screws for some
printers when installing without the
buffer pass unit. The brackets have a
number 2 stamped in the bottom
corner.
Install as shown with the bracket
marked "R" on the right side facing
you as you look at the exit side of the
upstream device. Install the bracket
marked "L" on the left side facing you.
Both brackets should be oriented with
the arrow facing up.
Before the system can be docked
correctly the paper guide on the
finisher needs to be removed. This is
not used on the finisher when in line
with the StreamPunch.
The docking bracket(s) provided with
the finisher should be attached to the
downstream side of the StreamPunch
with 4 size M4 screws.
Advertisement
Table of Contents
