Table of Contents
Advertisement
2. Tilt the storage rack up at the exit side so that the 2 cable shield screws [2] can be
removed.
Figure 4.14 Removing the Cable Shield Screws
4. With the cable shield removed, remove the die storage rack being careful not to
snag the exposed wires.
5. Remove the 2 hex head screws [3] holding the lower bypass panel to the rear
frame and the 2 hex head screws [4] holding the panel down at the front frame.
[3]
Figure 4.15 Removing the Lower Bypass
Screws, Rear
Figure 4.16 Removing the Lower Bypass
Screws, Front
62
[2]
[4]
Advertisement
Table of Contents
