Table of Contents
Advertisement
Section 7
Installation and Set Up
7.1 Recommendations and Pre-requisites
•
You will need the installation kit provided with the StreamPunch unit, which can be found in the
main carton.
•
If installing the StreamPunch downstream from a BK5000 Booklet Maker, a cover kit is required.
(Part No US – 404282EDP, EU – 961462EDP, AUS – 7708997)
•
Using a jogging unit on the finisher will improve the stack quality for binding purposes.
•
If installing the StreamPunch directly downstream of Pro C900 series, Pro C651/C751 EX or Pro
C751, contact your local service representative to obtain the correct entrance guide.
7.2 Unpacking
•
Inspect the outside of the package for shipping damage. If there is evidence of shipping damage,
contact the shipping carrier immediately.
•
Remove the punch from its shipping carton. Three people are recommended, one lifting at the
casters while two lift at the top cover. DO NOT lift using the front door panel.
•
Retain the smaller accessory box; it contains parts required for correct installation of the
StreamPunch.
•
Inspect for any concealed damage to the unit. If there is evidence of concealed shipping damage,
contact the shipping carrier immediately.
•
Remove all shipping tape from doors and levers.
7.3 Cable Connections
Review the table below to identify which section of the guide to refer to install the StreamPunch Pro/
Pro EX/ MP.
Section
Printers
3.1
Pro C900 series, Pro C550/700 & MPC6501/7501
3.2
MP6001/7001/8001/9001
3.2
MP6002/7502/9002
3.3
Pro 907/1107/1357EX
3.3
Pro C651 EX & Pro C751 EX
3.3
MP C8002/ C6502 & Pro C5100S/ C5110S
3.3
Pro 8100S/8110S/8120S
Refer to the following section when installing the SK5010 downstream of the StreamPunch Pro.
3.4
High Capacity Stacker
129
Finisher
SR5000
SR4050
SR4080
SR5020
SR5030/ SR5040
SR4110
SR5050/ SR5060
SK5010
Advertisement
Table of Contents
