Table of Contents
Advertisement
7. Remove the two rear Punch Module screws [5].
[5]
Figure 4.52 Punch Module Retaining Screws on Rear of Punch.
8. Remove the 4 power supply screws [6].
[6]
9. Cut wire harness ties as needed to release the punch wiring. If the punch module
is being removed for service then all wire ties/ cable clamps do not need to be
released. Proceed with removing the punch module and detach the cable clamps
when required.
Figure 4.53 Power Supply.
94
[6]
Advertisement
Table of Contents
