Table of Contents
Advertisement
1.4.10.1 Aligner Idler Roller Maintenance
Aligner idler rollers press the paper against the
paper for punching and exiting. To replace the idler rollers, see "Aligner Idler Roller
Removal" on page 4.5.1.
Maintenance Schedule
Inspect and clean every 750K cycles.
Procedure
•
Make sure the aligner rollers are clean.
•
Ensure that the idler rollers maintain pressure against the Aligner belt (green
belt).
•
Inspect for bent or damaged parts.
Warning: Disconnect the StreamPunch Pro from power and retain the power cord in
your possession for your safety. Failure to observe this warning could result in death
or serious injury.
To inspect the aligner idler rollers:
1. Press the bracket [1] of each roller. The roller should move away from the
Aligner belt (green belt) drive and then when released, they spring back into
place.
Figure 1.15 Alignment Roller Inspection (rear aligner rollers shown).
27
and align the
Aligner belts (green belt)
[1]
[1]
[1]
Advertisement
Table of Contents
