Table of Contents
Advertisement
4.5.3.1 Paper Entrance Side Aligner Belt (Green Belt) Replacement
1. Disconnect the entrance sensors wire from the side frame.
2. Remove the 4 screws that secure the front paper chute [1].
[2]
3. To remove the J2 Latch, Door Latch [2].
a. Unhook the spring of the J2 Latch on the right end.
b. Remove only one (the one closest to the frame) of the E-rings of the J2 Latch on
the left end (front Door side).
c. Push the J2 latch in toward the front door until it clears the rear frame.
d. Pull the entire J2 latch, door latch out and set it aside.
Figure 4.25 Remove 4 Paper Chute Screws.
71
[1]
Advertisement
Table of Contents
