Setting Menu 8: Special Settings (Settings For Operating Time And Iec Mode) - Mitsubishi Electric ME96SSEB-MB User Manual

3. How to Set up
Setting Menu 8: Special Settings (Settings for Operating Time and IEC Mode)
This section describes the settings of the operating time and IEC mode.
In the operating mode, press the
following operation.
For details about each function, refer to the corresponding section.
Operating time ⇒ See 5.2.4 to 5.2.5.
Setting Menu
DISPLAY SET
①Operating time
Display
DISPLAY SET
②Operating time 1
Count target
settings
DISPLAY SET
③Operating time 1
Threshold
DISPLAY SET
④Operating time 2
Count target
settings
DISPLAY SET
and buttons simultaneously for 2 seconds or more to enter the
RESET
SET
Select 8 in the setting menu.
*Refer to the right figure.
Set whether to display the operating time, which integrates
input time of count target and is displayed as load
operating time.
oFF
（Not display） （Display）
Select a count target of operating time 1 from auxiliary
power, current, or voltage.
AUX
(Auxiliary power) (Current)
Item 3-phase 4-wire 1-phase 2-wire
AUX AUX
A A
AVG
（L-N）
V
V
AVG
Set the threshold of operating time 1 count.
When you select auxiliary power (AUX) at operating time1, this screen is not
displayed.
(1) When you set the counting target of operating time 1 to current:
min 1 to 120%
(Setting step 1%)
*If you select "min", the operating time will be counted
at current display of other than 0 A.
(2) When you set the counting target of operating time 1 to voltage.
min 20 to 120%
Setting step 1%)
(
*If you select "min", the operating time will be counted
at voltage display of other than 0 V.
Select a count target of operating time 2 from auxiliary power, current, or
voltage.
The setting method is the same as ②Operating time 1 Counting target
settings.
on
A V
(Voltage)
Others
AUX
A
V
V
AVG
30
AUX
A
AVG
（L-L）