Setting Menu 1: Basic Setup (Settings For Phase Wire System, Display Pattern, Vt/Direct Voltage, And Ct Primary Current) - Mitsubishi Electric ME96SSEB-MB User Manual

3. How to Set up
Setting Menu 1: Basic Setup (Settings for Phase Wire System, Display Pattern,
VT/Direct Voltage, and CT Primary Current)
You will set the phase wire system, display pattern, VT/Direct voltage, CT primary current, and demand time
period.
In the operating mode, press the
following operation.
Setting Menu
DISPLAY SET
①Phase wire system
DISPLAY SET
②Display Pattern
DISPLAY SET
and buttons simultaneously for 2 seconds or more to enter the
SET RESET
Select 1 in the setting menu.
*Refer to the right figure.
Set the phase wire system
according to the measurement target circuit.
3P4: 3-phase 4-wire
3P3. 2CT: 3-phase 3-wire（2CT）
3P3. 3CT: 3-phase 3-wire（3CT）
1P3. 1N2: 1-phase 3-wire（1N2 display）
1P3. 1N3: 1-phase 3-wire（1N3 display）
1P2: 1-phase 2-wire
Set the display pattern.
P01 P02 P00
The following table shows measuring elements displayed on
each display pattern. The measuring elements displayed on P01
and P02 are the same. For P01, four elements are displayed in
one screen. For P02, each phase is displayed in one screen. For
details, refer to 6.1.
P00 is a special display pattern to freely set display items. For
details on the settings, refer to 3.13.
○：Displayable only by this setting
△：Other additional settings are necessary to display.
□：Select 'P00' and set up the display order and position.
1) When set to 3-phase 4-wire system
P01 ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
P02 ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
P00 □ □ □ □ □ □ □ □ □ □ □ □ □
Continued to the next page.
Note: The underlined
shows the default
setting.
(The same as below)
<When 1-phase 2-wire is set at
①Phase wire system.>
P02 is not selectable.
19
Additional Screen
*Note
○ ○ ○ △ △
○ ○ ○ △ △
△ △ △ △ △