Each Mode Function - Mitsubishi Electric ME96SSEB-MB User Manual

2.

Each Mode Function

The instrument has the following operation modes.
When auxiliary power is supplied, the operating mode is first displayed.
Depending on the application, switch the operation mode to use.
Mode
Operating This is a normal operation mode to display each measured value in digital
numerical number. In the operating mode, there are 'Present value display' that
mode
shows values at present and 'Max/Min value display' that shows maximum and
minimum values in the past.
In addition, on each display screen, the cyclic display mode, which
automatically switches the display screen every 5 seconds, is available.
Setting This is a mode where you can change the settings for measurement function.
mode In addition, on the CANCEL screen, which is the screen to cancel the setting
change, the following special operations are available.
・ Restart the instrument.
・ Reset the settings to the factory default.
Setting This is a mode where you can confirm the setting of each item.
confirmation In this mode, you cannot change the settings. Therefore, it is possible to
mode prevent from accidentally changing the settings.
(Test mode) The mode provides test function available at startup of systems.
・ Communication Test: Without measurement input (voltage/current), fixed
・ Support function for checking input wiring:
■Flow of each mode
Operating mode
Present value
display
Max/Min value
display
Description
numerical data can be returned.
When either a voltage input or current input is
incorrectly wired, the incorrect wiring part is displayed
on the screen. In addition, useful information is also
displayed such as a current phase angle and voltage
phase angle.
Press for 2 seconds simultaneously.
＋
SET RESET
SET
End screen
Save the
settings
＋ －
SET
CANCEL
screen
Cancel the
settings
Press
SET
SET
When you select
"End" in the menu
15
Setting mode
SET
When you
select "End"
in the menu
confirmation mode
for 2 seconds
Test mode
Reference
5 Operation
3 How to
Set up
3.10 or 4
How to Use
Test Mode
ON
Setting
Blink