Active Energy/Reactive Energy/Apparent Energy Display; How To Change The Display Digit Of Active/Reactive/Apparent Energy - Mitsubishi Electric ME96SSEB-MB User Manual

5. Operation
5.1. Basic Operation

5.1.8. Active Energy/Reactive Energy/Apparent Energy Display

■
Display type
The following table shows the display type of active/reactive/apparent energy based on full-load power.
Full-load power [kW] =
*1. For 3-phase 4-wire system, VT primary voltage and direct voltage are
calculated using phase voltage.
*2. For 1-phase 3-wire system, VT primary voltage is calculated using phase
voltage.
*3. For the direct voltage setting, direct voltage is used for calculation instead of
VT primary voltage.
*4. For reactive energy and apparent energy, 'kW' in the above equation is read
as 'kvar' and 'kVA' respectively.
Full-load power [kW]
Below 10
10 or more and below 100
100 or more and below 1000
1000 or more and below 10000
10000 or more and below 100000
100000 or more
■Display examples
Active energy (Imported) Active energy (Exported)*1
Reactive energy
(Imported lag)

5.1.9. How to Change the Display Digit of Active/Reactive/Apparent Energy

By changing the unit (M, k, or none) of active/reactive/apparent energy or by displaying the lower enlarged
view, you can check the upper or lower digit of a measured value.
Press and simultaneously for 2 seconds to switch.
＋ －
Example of switching active energy (imported): 012,345,678,901,234.567Wh
Press and
＋
Unit：M
Note1: Active, reactive, and apparent energy that are not displayed on the screen will be also all changed to the same unit.
Note2: If the set value of VT primary voltage or that of CT primary current is large, the lower digit less than the
measurement range will indicate '0.'
α x (VT primary voltage) x (CT primary current)
1000
Display type
Digital
Display
kWh, kvarh, kVAh
*The unit can be
changed to 'M or none.'
888888
MWh, kvarh, kVAh
*The unit can changed
to 'k or none.'
Reactive energy
(Imported lead) *1
simultaneously for 2 seconds
－
Lower enlarged
Unit
The measurement display blinks
at measuring active energy
(imported). It becomes OFF or
ON at no measuring point.
To display the screen of *1, you must
change the settings for active/reactive
energy measurement in 3.4.
Apparent energy
Reactive energy Reactive energy
(Exported lag)*1 (Exported lead)*1
Unit: None
49
α: 1 1-phase 2-wire
2 1-phase 3-wire
√3 3-phase 3-wire
3 3-phase 4-wire
Active energy
measured value
Measurement
display
Unit: k