Mitsubishi Electric ME96SSEB-MB User Manual page 22

3. How to Set up
3.2 Setting Menu 1: Basic Setup (Settings for Phase Wire System, Display Pattern,
VT/Direct Voltage, and CT Primary Current)
DISPLAY SET
④CT current
DISPLAY SET
Continued form the previous page.
(2) For measurement with VT
<Secondary voltage setting>
(a) When set to 3-phase 4-wire system (Phase voltage)
63.5 V 100 V
(b) When set to 3-phase 3-wire (2CT, 3CT) /1-phase 2-wire (Line voltage)
100 V 110 V
<Primary voltage setting>
The factory default settings:
・For 3-phase 4-wire system ⇒ 200 V (Phase voltage)
・For 3-phse 3-wire/1-phase 2-wire system ⇒ 10000 V
・From the upper digit, set the blinking digit with
・By pressing
, move the setting digit, blinking one, to a lower digit.
SET
・By pressing
, move the setting digit, blinking one, to an upper digit.
DISPLAY
・The setting ranges from
*If you set out of range, the error message (E05) will appear.
If the error message appears, press
set it again.
・By pressing
at the lowest digit, shift to the next setting item.
SET
Set the settings for CT.
You will set the primary and secondary current of CT.
<Secondary current setting>
1 A 5 A
Note: CT is Current Transformer.
<Primary current setting>
The factory default setting: 5.0 A
・From the upper digit, set the blinking digit with
・By pressing
, move the setting digit, blinking one, to a
SET
lower digit.
・By pressing
, move the setting digit, blinking one, to
DISPLAY
an upper digit.
・The setting ranges from 1.0 A
The setting unit is A.
*If you set out of range, the error message (E05) will appear.
If the error message appears, press
settings to set it again.
・By pressing
at the lowest digit, shift to the next setting
SET
item.
110 V 115 V
220 V
(Line voltage)
＋
60 V to 750000 V. The setting unit is V.
and then review the settings to
SET
or
＋
to 30000.0 A.
and then review the
SET
21
120 V
or .
－
.
－