Product Overview; Ap410I/E Features - Extreme Networks ExtremeWireless AP410i Installation Manual

Product Overview

AP410i/e Features
AP310i/e AP410i/e Power Source
AP410i/e Power Tables
LED Indicators
Purchase Order Information
The AP410i/e access points are indoor model 802.11ax access points. The "i" in AP410i indicates that the
access point comes with internal antennas, and the "e" indicates that it comes with external antenna
connectors. The access points feature built-in dual-band radios, two band-locked radios, eight WiFi
internal or external antennas, and one Bluetooth Low Energy (BLE) antenna.
The AP410i/e can be mounted on a flat surface such as a wall, a solid flat ceiling, or to a junction box or
gang box, and on a suspended or drop ceiling.
Note
The AP410i/e requires a minimum base firmware of WiNG 7.3.0.
In this document, the access points are addressed as AP410i/e when the product features and
installation procedures are the same for both access points.

AP410i/e Features

•
Radios: Three 802.11ax radios
◦
One 2×2 2.4 GHz radio
◦ One 4×4 5 GHz radio
◦
One 2×2 2.4 GHz and 5 GHz radio
•
One 2.4 GHz IoT radio
•
Console port: RJ45
•
Two Ethernet ports:
◦ 1 × 10/100/1000 Mbps auto-negotiation Ethernet port, RJ45
◦
One multi-rate GE/2.5 GE Ethernet port
•
LED indicators: Seven
All LED indicators will be powered on during reset and will connect to general purpose input/output
(GPIO) pins.
8 ExtremeWireless™ Access Points AP410i/e
on page 8
on page 9
on page 9
on page 10
on page 10