Table of Contents
Advertisement
Install the Access Point on a Beam
3. Place the beam clip accessory on a beam.
4. Tighten the beam clip accessory screw to secure the access point in place.
Figure 11: Beam clip accessory attached to a beam
5. Connect the Ethernet cable RJ45 into the GE1 port.
30
ExtremeWireless™ Access Points AP410i/e
Note
Ensure that you leave enough space between the beam clip accessory screw and the
clamp. This helps to tighten the beam clip accessory screw easily.
Install the Access Point
Advertisement
Table of Contents
Need help?
Do you have a question about the ExtremeWireless AP410i and is the answer not in the manual?