Mechanical Specification; Module Dimension; Height On Top; Height On Bottom - Kontron nanoETXexpress-SP User Manual

Hide thumbs Also See for nanoETXexpress-SP:

Table of Contents

3.8

Mechanical Specification

3.8.1

» 55mm x 84mm (±0.2mm)

3.8.2

» Maximum approx. 3.5mm (withouth printed circuit board)

» Height is depending on (optional) CPU cooler / heat spreader

3.8.3

» Maximum appprox. 3.5mm (without printed circuit board)

3.8.4

All dimensions are shown in millimeters. Tolerances should be ± 0.25mm [±0.010"], unless otherwise noted. The

tolerances on the module connector locating peg holes (dimensions [16.50, 6.00]) should be ± 0.10mm [±0.004"]. The

220 pin module connector shall be mounted on the backside of the PCB and is seen "through" the board in this view. The 4

mounting holes shown in the drawing should use 6mm diameter pads and should have 2.7mm plated holes, for use with

2.5mm hardware. The pads should be tied to the PCB ground plane.

CAD drawings are available at

EMD CustomerSection

Table of Contents