Troubleshooting; Parts And Service; And Canada; Worldwide - Ferno 101-H User Manual

Troubleshooting, Parts and Service
Problem
One or both ends of the table will not raise
to the maximum height.
The hydraulics stick.
The table exhibits any other type of
hydraulic problem.
8.1 U.s.a. and Canada
In the United States and Canada, to order parts or for professional
table repair, contact EMSAR
®
to manage, service, and repair Ferno products.
Telephone (Toll-Free)
Telephone
Fax
Internet

8.2 Worldwide

To order Ferno parts, and for professional table repair, contact your
Ferno distributor. Your distributor is the only agent authorized by
Ferno to manage, service, and repair Ferno products.

8.3 Parts Diagrams

8
14

7 - TrOUblesHOOTing

Air has been forced into the hydraulic
reservoir.
The left pedal may have been pumped after
the table top was raised to its maximum
height.

8 - ParTs anD serviCe

- the only agent authorized by Ferno
1.800.73.EMSAR
1.937.383.1052
+1.937.383.1051
www.emsar.com
Model 101-H Operating Table
Cause
improper parts and service can cause injury. Use
only Ferno parts and Ferno-approved service on
the table.
Modifying the table can cause injury and damage.
Use the table only as designed by Ferno.
17
© Ferno-Washington, Inc 234-1994-03 October 2010
resolution
Using two people:
First Person: Hold down the center and
●
right pedals (as when lowering)
second Person: Repeatedly press the
●
left pedal (as when raising)
First Person: Allow the table to be raised
●
intermittently by releasing and pressing
the center and right pedals again
Continue until the table is at its full
●
height.
Repeat the process if needed.
●
Apply a small amount of downward hand
pressure on the table top to free up the
hydraulics.
Contact Ferno Customer Relations (page 2)
or your Ferno distributor.
Warning
Warning
15